Bug on impluse T2

[gianni]

Hi, when making a blind scan on terrestrial the LCN is not working. Channels are stored not using LCN assignmemt.
Can anyone confirm this behaviour?
Thanks.

[Stiaga]

Hi Gianni,
I have the same issue.

I have also checked that if you scan only one transponder it works correctly.

What firmware version do you use?

[mascalzone]

hi guys, impulse t2 can it use cccam protocol? tnx

[gianni]

Hi stiaga, I tried with original version 2.2.10 and the only emu available.
@mascalzone, yes it works with cccam.

[gianni]

With the new sw release 2.2.32 the LCN apparently works but it is still not fine.
The impulse mix radio channels and tv channels as a matter of fact when you select achannel you can listen to it but not see it.
There is a still a lot of work to do on it.
Rgds.

[gianni]

Just checked the version 2.2.36 but it has the same problem of 2.2.32.
The LCN works but a lot of TV channels are seen as Radio channels. So is possible to listen but not to see.
At the moment the only working version is 2.2.10 but with this version the LCN does not work fine.

P.S.
Terrestrial channels from 61 to 69 are now reserved to LTE/4G. It would be better to stop searching at ch60.

Rgds.