Re: amiko micro hd se
 

The preparation of receiver:
1st step unplug power cord
2nd step load firmware in upgrage tool(make alive my stb chip 3511)
3rd step select allsw+bootloader,tick upgrade not dump,click next and fast plug back power cord of your receiver.Good luck !

Re: amiko micro hd se
 

sorry my friend you and me we are trap we have flash with this AMIKO_MicroHD_SE_Starlight_2.0.78_by Dekolte.rar posted by edoroki
today i change my receiver because this SW is not good and i you flash this once you want be able to change it again to another SW it will be stuck on this SW

Re: amiko micro hd se
 

is there a plugin for amiko micro hd se to add this option to my receiver

Re: amiko micro hd se
 

The last comment was some time ago. But I faced the same problem now (STB freezed) and found the solution how to burn original firmware to Amiko micro HD SE via RS232. May be it will be of help to others.
I used the analog Video-Cable supplied with the Box (lengths of different 4-ring 3,5mm jack may not suit, as the 4th ring here is longer than others) and connected it via wires to the RS232 (see picture):

RS232: VideoCable RCA-Plug: VideoCableJack:
Pin 5 = GND any outer ring 4th ring
Pin 2 = R (eceive) yellow tip 3rd ring
Pin 5 = GND red tip 2nd ring
Pin 3 = T (ransmit) white tip 1st ring (tip

Software: (better use Windows XP):
1.) connect rs232 with Amiko micro HD SE physically (by cable) and plug power cable to receiver
2.) connect rs232 with Amiko micro HD SE by Software “Universal Upgrade SD-HD by Dekolte”
3.) download/ burn firmware from PC to Receiver with “Universal Loader SD-HD by Dekolte”
(have time! it downloads 2 times 0-100%, then it burnes)
Remarks: - if Step 2 or 3 doesn't work: unplug power cable and
fast plug it after clicking “next” at step 3.)
- select “all sw+bootloader” / tick “upgrade” not “dump”