Re: amiko micro hd se
The last comment was some time ago. But I faced the same problem now (STB freezed) and found the solution how to burn original firmware to Amiko micro HD SE via RS232. May be it will be of help to others.
I used the analog Video-Cable supplied with the Box (lengths of different 4-ring 3,5mm jack may not suit, as the 4th ring here is longer than others) and connected it via wires to the RS232 (see picture):
RS232: VideoCable RCA-Plug: VideoCableJack:
Pin 5 = GND any outer ring 4th ring
Pin 2 = R (eceive) yellow tip 3rd ring
Pin 5 = GND red tip 2nd ring
Pin 3 = T (ransmit) white tip 1st ring (tip
Software: (better use Windows XP):
1.) connect rs232 with Amiko micro HD SE physically (by cable) and plug power cable to receiver
2.) connect rs232 with Amiko micro HD SE by Software “Universal Upgrade SD-HD by Dekolte”
3.) download/ burn firmware from PC to Receiver with “Universal Loader SD-HD by Dekolte”
(have time! it downloads 2 times 0-100%, then it burnes)
Remarks: - if Step 2 or 3 doesn't work: unplug power cable and
fast plug it after clicking “next” at step 3.)
- select “all sw+bootloader” / tick “upgrade” not “dump”
|